AppLevelSettings
Last updated
Last updated
ppm|amm-run status:
on: continue execute copy trade buy
off: stop execute copy trade buy (auto-selling will not affected by this)
ppm short for PumpFun
amm short for PumpAmm or Raydium
copy trade when hold
on: always execute copy trade no matter you hold or not.
off: if CA you have stock, stop auto buy.
filterCAName:/tokenNameMaxLen:
filterCAName: on: only copy trade CA name endswith pump.
filterTokenNameMaxLen: only copy trade token name lens LessOrEqual maxLen.
buy times of the same CA:
advise only copy once, the times here have 2 meanings:
your successful buy times of the CA.
smart money buy times of the CA.
copier-mark: the remark info used for yourself could easily remeber.
copier-keypair:
pubkey: your wallet address
privatekey: your wallet privatekey
if you input your privatekey, turbo will auto convert it to encrypt seckey.
after your first time click "save app conf" button, you could delete this or restart software, it will be deleted automatically.
privatekey and seckey will not stored on your locally PC.
ppf|amm-BAL lower:
when SOL balance lower than setting value, turbo will push notification message like "BalanceNotEnough" and auto stop ppf copy trade.
when WSOL balance lower than setting value, turbo will push notification message like "BalanceNotEnough" and auto stop amm copy trade.
after auto stop execute, if you want restart it, please manual toggle on ppf or amm run status.
top 10 hold ratio: before copy trade, check CA's top10 holder ratio, if over than setting value, will not copy trade.
delay sell seconds when mig:
due to extreme price volatility at migration, you may configure a delay seconds for sell after sell trigger when mig.
sell orders triggered before migration but not success sell will not be affected by this.
set to 0 to diable this conf.
DevSell%:
If toggle on, when dev sell and reach ratio, will auto execute sellout. and the below 2 kind type of ratio should both reach ratio:
ratio = devSellTokenAmount/(hisHoldAmountBeforeSell)
posRatio = devSellTokenAmount(myCurrentHoldAmount)
if this param is not included and only use ratio control whether sellout, then the dev's sell ratio will significantly impact user's selling:
Assume the ratio is 30%. If dev buys 100 tokens and you buy 100,000 tokens, a difference of 1,000 times
if the dev sells 30 tokens, then you would follow by selling 100,000 tokens.
in this scenario, it would clearly be unreasonable.
if you don't want to use these param, keep it to 0
DevBuyAmountRange:
This conf not means dev's current hold amount.
It's dev's total buy solCost amount since CA been deployed.
only copy trade when dev's buy solCost in range.
Wallet blacklist:
If an address in wallet blacklist bought a CA, will not execute copy trade buy the CA anymore.
main scenario:
some SmartMoney always rug when you copy them
they always buy CA use there alt account first and then buy it with main account, then you copy trade them, finally they use alt account rug it.
you could add there alt account in wallet blacklist first and avoid these happened.
CA blacklist: will not buy CA in blacklist anymore.
when you first buy a CA, SOLANA will receive 0.00203928SOL for rent fee.
use this free function can batch close ATA account and get rent fee back.
another thing you should know, if your wallet have many unclosed ATA account, it'll slow down the land rate and speed. So you'd better close ata account less than 30.
